PPC-IPS interface: phoenix connected 5P 5.08 pitch
Note!
1.
2.
3.
3.2
PS_ON shut down mode setting
Users must set PS_ON as PC system shut down function, make sure there's no
other software to shut down system after PS_ON start. The following steps detail how
to set PS_ON as the shut down function.
1.
Left click on "Start (push button)" in "Start"
The RS-232 is used to control IPS by AP. If the user does not use
AP to control IPS, the RS-232 should be left unconnected.
Need to set PC PS_ON as shut down mode, and must ensure
there's no other program to interrupt when PS_ON single send out.
DC-IN power wattage need 20 W lager than DC-OUT wattage, that
can ensure battery charging at normal status. So we strongly sug-
gest power supply wattage need above 90W.
23
PPC-IPS User Manual