Introduction; Intended Use - mru OPTIMA User Manual

2

Introduction

• This manual enables you to understand and safely operate this MRU
Analyser.
• Please read this manual with great vigilant and get familiar with the
product before using it.
• This Analyser may only be operated by competent personnel and for
its intended use.
• Please pay special attention to all safety directions and warnings to
prevent personal injuries and damaging of the product.
• We can't be held responsible for any injuries and/or damages that
occur by not following the instructions in this manual.
• Always keep the manual near you when working with the analyser, to
be able to read instructions as needed
• Please ensure to hand over all documents to when handing the ana-
lyser over to others.

2.1. Intended use

The Analyser is intended for short-term measurement in the context of
emission control measurements and adjustments at small furnaces. The
analyser measures the measurements provided by VDI4206 and
EN50379 metrics and stores them for further processing.
The analyser is specifically not intended as a safety device or personal
protective equipment.
The analyser should not be used as a warning device to warn people
against the presence of harmful gases.
The analyser must be used according to instructions for the intended
use.
Our analysers are checked according to the following regulations:
VDE 0411 (EN61010) and DIN VDE 0701 before they leave the MRU
GmbH factory.
MRU technical products are designed and manufactured according to
DIN 31000/ VDE 1000 and UVV = VBG 4 of the professional guilds for
fine mechanics and electrical engineering.
MRU GmbH assures that the analyser complies to the essential require-
ments of the legal regulations of the member states of the electro-mag-
netic compatibility (2014/30/EU) and to the low-voltage regulations
(2014/35/EU).
MRU GmbH, D-74172 Neckarsulm
USER MANUAL OPTIMA
10 / 110