Axis C2005 User Manual page 8

AXIS C2005 Network Ceiling Speaker
Additional settings
5. Click the copy icon for the link.
- The link will have this format:
http://[audiodeviceIP]/axis-cgi/playclip.cgi?location=/[path]/camera_cli-
cks.mp3&repeat=2&volume=45
Create a rule:
1. Go to the device interface of the camera, by entering its IP address in a web browser.
2. Go to System > Events > Recipients.
3. Click Add recipient.
4. Type a name for the recipient, for example "Speaker".
5. Select HTTP from the Type drop-down list.
6. Paste the configured link from the audio device in the URL field.
7. Enter the user name and password for the audio device.
8. Click Save.
9. Go to Rules.
10. Click Add rule.
11. Type a name for the action rule, for example "Play clip".
12. Under Condition, select a video motion detection alternative.
Note
If there are no options for video motion detection, then go to Apps and make sure the AXIS Video Motion Detection
application is installed and turned on.
13. Under Action, select Send notification through HTTP.
14. Under Recipient, select your recipient.
15. Click Save.
Set up direct SIP (P2P)
Use peer-to-peer when the communication is between a few user agents within the same IP network and there is no need for extra
features that a PBX-server could provide. To better understand how P2P works, see Peer-to-peer SIP (P2PSIP) on page 11 .
For more information about setting options, see SIP on page 26.
1. Go to System > SIP > SIP settings and select Enable SIP.
2. To allow the device to receive incoming calls, select Allow incoming calls.
3. Under Call handling, set the timeout and duration for the call.
4. Under Ports, enter the port numbers.
- SIP port – The network port used for SIP communication. The signaling traffic through this port is non-encrypted.
The default port number is 5060. Enter a different port number if required.
- TLS port – The network port used for encrypted SIP communication. The signaling traffic through this port is
encrypted with Transport Layer Security (TLS). The default port number is 5061. Enter a different port number
if required.
8