Advertisement
UpDown Desks Australia Pty Ltd
ABN: 16 620 407 317
Once in position, use all 4 screws to attach the drawer to the desktop. The self‐tapping
screws are typically sharp enough to allow you to use a hand screwdriver to screw firmly
into the desktop with a reasonable level of force. If you find this difficult, you may benefit
from pre‐drilling the holes with a 2.5mm drill bit.
Note on pre‐drilling: Be extremely careful not to drill too far as you may run the risk of drilling
all the way through the desktop!
3. Notes
The drawer runners of the metal drawer are typically firm and have been designed this way.
They will loosen over time however.
Should you need to remove the drawer from the runners, this can be achieved by activating
the levers on both runners. One side you will need to push down, the other side push up at
the same time; the drawer will slide right out.
© 2022 UpDown Desks Australia Pty Ltd All Rights Reserved
P: 1300 650 773
E: contact@updowndesk.com.au
Advertisement
