UpDown Desks Australia Pty Ltd
ABN: 16 620 407 317
1. Positioning
Installation on a 750mm deep desktop should result in the metal drawer face sitting
approximately flush with the front edge of the desktop when viewed from above (only the
handle will protrude). Naturally, it will protrude slightly more or less if your desktop is
deeper or shallower.
Providing all 4 self‐tapping screws are utilised and screwed through the drawer screw holes
into solid desktop material, there are no real constraints as to which lateral location you
position the drawer (far LHS, far RHS or anywhere in between).
You can even position the drawer so that the 'wing' from the frame sits within the open
space (example shown below).
© 2022 UpDown Desks Australia Pty Ltd All Rights Reserved
P: 1300 650 773
E: contact@updowndesk.com.au