GE JCAS745 Owner's Manual And Installation Instructions page 81

ELECTRICAL CONNECTIONS (CONT.)
3 POWER CORD AND STRAIN RELIEF
INSTALLATION
A
Remove the wire cover (on the back of the range) by removing
two (2) screws using a Phillips screw driver.
Do not discard these screws.
2 screws
to remove
wire cover
Back of Range
B
Remove the knockout ring (1 3/8") located on bracket directly
below the terminal block. To remove the knockout, use a pair
of pliers to bend the knockout ring away from the bracket and
twist until ring is removed.
Knockout ring
in bracket
Installation Instructions
Wire cover
Terminal block
(appearance
may vary)
Knockout ring
removed
C
For power cord installations only (see the next step if using
conduit), assemble the strain relief in the hole. Insert the
power cord through the strain relief and tighten. Allow enough
slack to easily attach the cord terminals to the terminal block.
If tabs are present at the end of the winged strain relief, they
can be removed for better fit.
NOTE: Do not install the power cord without a strain relief.
The strain relief bracket should be installed before rein-
stalling the rear range wiring cover.
Strain relief
Power cord
Skip to Step 4 or 5.
D
For conduit installations only, purchase a squeeze connec-
tor matching the diameter of your conduit and assemble it in
the hole. Insert the conduit through the squeeze connector
and tighten. Allow enough slack to easily attach the wires to
the terminal block.
NOTE: Do not install the conduit without a squeeze connector.
The squeeze connector should be installed before reinstalling
the rear range wiring cover.
Squeeze
connector
Conduit
Skip to Step 6 or 7.
Terminal
block
Bracket
Terminal
block
Bracket
81