(4) Ink absorber counter setting
Set the ink absorber counter value to a new EEPROM after the main PCB ass'y is replaced in servicing.
1)
Before replacement of the main PCB ass'y, check the ink absorber counter value in EEPROM
Information Print.
2)
Replace the main PCB ass'y.
3)
After replacement, the ink absorber counter value should be set in the service mode using the Service
Tool.
In the Ink Absorber Counter section of the Service Tool, select Main, from the Absorber pull-down
menu.
From the Counter Value(%) pull-down menu, select the value (in 10% increments) which is the
closest to the actual counter value confirmed before replacement of the main PCB ass'y, and click
Set.
4)
Print EEPROM information to confirm that the value is properly set to the EEPROM.
Set the ink absorber counter value to EEPROM after the ink absorber partial replacement.
1) Replace the Absorber Kit (Partial).
2) The ink absorber counter value should be set to 30% using the Service Tool.
In the Ink Absorber Counter section of the Service Tool, select Main, from the Absorber pull-down
menu.
From the Counter Value(%) pull-down menu, select 30, and click Set.
(54/80)
easyfixs.blogspot.com
QY8-13EX-040