Advertisement
INSTALLER AND OWNER GUIDE
2. Place the left-hand ceramic front coal
in position in front of the base coal. The
front of the ceramic coal should touch the
front of the burner module (See figure 2).
3. Place the right hand ceramic front coal
in position in front of the base coal. This
should overlap the left-hand coal. Push
the two sides together to minimise the
gap. The front of the ceramic coal should
touch the front of the burner module (See
figure 2).
4. It is important that the front ceramics
are positioned correctly and do not cover
the burner ports in any way (See figure
2).
Install the 12 loose coals as follows. The
underside of each coal is marked with a
letter 'A' to 'L' and an arrow.
Figure 2. Front coal location
The coals should be positioned so that the
arrows always point towards the back of the firebox. When located into position the
stem of each arrow should be at 90° to the rear of the firebox.
5. Hold coal 'A' upright with the arrow
pointing to the top. Locate coal 'A' as
shown in figure 3.
Figure 3. Front row "Coal A"
Page 3
Advertisement
