Advertisement
INSTALLER AND OWNER GUIDE
SAFETY
This product uses fuel effect pieces and burner compartment walls containing
Refractory Ceramic Fibres (RCF), which are man-made vitreous silicate fibres.
Excessive exposure to these materials may cause irritation to eyes, skin and
respiratory tract. Consequently, it is important to take care when handling these
articles to ensure that the release of dust is kept to a minimum. To ensure that the
release of fibres from these RCF articles is kept to a minimum, during installation
and servicing we recommend that you use a HEPA filtered vacuum to remove any
dust and soot accumulated in and around the fire before and after working on the
fire. When replacing these articles we recommend that the replaced items are not
broken up, but are sealed within a heavy duty polythene bag, clearly labelled as
RCF waste. This is not classified as "hazardous waste" and may be disposed of at a
tipping site licensed for the disposal of industrial waste. Protective clothing is not
required when handling these articles, but we recommend you follow the normal
hygiene rules of not smoking, eating or drinking in the work area and always wash
your hands before eating or drinking.
This appliance does not contain any component manufactured from asbestos or
asbestos related products.
FITTING THE CERAMIC COAL FUEL EFFECT
The ceramic fuel effect may cause staining / discolouration to decorative surfaces. It is
therefore advisable to protest decorative surfaces.
Note: Depending upon model the detail around the ceramic fuel effect may be different
to that shown.
1. Place the ceramic base coal in the burner compartment. The bottom rear face of the
coal should rest on the
angled ledges at the back
of the burner
compartment. The
bottom front recess
edges on the coal base
should locate against the
tags at the front of the
ceramic support (See
figure 1).
Figure 1. Ceramic base location
Page 2
Advertisement
