IKEA MATMASSIG Manual page 39

ENGLISH
Problem
The residual heat indicator is
not displaying anything.
There is no signal when you
touch panel symbols.
lights up on the power
setting display.
symbol plus a number
appears on the timer dis-
play.
lights up on the timer
display, after activating the
appliance.
lights up on the timer
display.
Possible cause
The cooking zone was only
on for a short time and is
therefore not hot.
The signals are deactivated. Activate the signals. Refer to
Unsuitable cookware.
No cookware on the cooking
zone.
The diameter of the bottom
of the cookware is too small
for the cooking zone.
Electronic component error.
The electrical connection is
incorrect.
Overheating protection for
the cooking zone operates.
Remedy
If the cooking zone is sup-
posed to be hot, call the Af-
ter Sales Service.
OffSound Control.
Use suitable cookware.
Place cookware on the cook-
ing zone.
Move onto a smaller cooking
zone.
Disconnect the appliance
from the electrical supply for
a few minutes. Remove the
fuse, wait one minute, and
insert the fuse again. If the
problem continues, ensure a
correct installation by calling
an authorised installer.
Check if the appliance is cor-
rectly connected to the elec-
trical supply. Ensure a cor-
rect installation by calling an
authorised installer.
Deactivate the appliance.
Remove the hot cookware.
After approximately 30 sec-
onds activate the cooking
zone again. should dis-
appear, residual heat indi-
cator can stay. Cool down
the cookware and check it
with the section "Cookware
for the induction cooking
zones".
39