Before Using The Water Dispenser; Cleaning Before Use; Before Using Your Unit - Logik LSBSDX20 Instruction Manual

INSTALLATION

Before Using the Water Dispenser

Before using the water dispenser, clean the water tank first.
1. Take out the water tank by gripping it tightly on both
sides, then keep pulling it upward and downward with
some force until removed.
2. Take off the water tank cover, and wash the water tank,
valve and its cover. After washing, drain the water from
inside the tank and replace the cover.
3. Insert the water tank valve into the water dispenser hole
first.
Be careful not to press on the tank valve.
4. Fit the water tank along the guides on the door. Press down on both sides of the water
tank.
5. When a click is heard, that means the installation is completed.

Cleaning Before Use

Wipe the inside of the unit with a weak solution of bicarbonate soda. Then rinse with warm
water using a sponge or cloth. Wipe completely dry before replacing the shelves, drawers and
salad bin. Clean the exterior of the unit with a damp cloth.
If you require more information refer to the Cleaning section.
• Before Plugging in YOU MUST
Check that you have a socket which is compatible with the plug supplied with the
unit.
• Before Turning On!
Do not turn on until two hours after moving the unit. The coolant fluid needs time
to settle.

Before Using Your Unit

Before placing any food in your unit, turn it on and wait for 24 hours, to make sure it is
working properly and to allow it time to fall to the correct temperature. Your unit should not
be overfilled.
6
Guide
Tank valve
Dispenser hole
1
2