JUKI HZL-30Z Instruction Manual page 24

Even feed foot
1.
Pattern to be used
HZL-30Z
HZL-60
This even feed foot is gen-
Lift presser bar, remove presser foot clamp
erally used for fabrics (such
screw and presser foot holder.
as knits, jersey, vinyl cloth,
artificial leather and leather)
that are difficult to be fed by
sewing machine. It ensures
smooth feed of fabric while
preventing fabric slippage
to achieve neatly finished
seams.
CAUTION:
Make sure to turn off the machine
before changing the presser foot.
Rolled hemming foot
1.
Pattern to be used
HZL-30Z HZL-60
Fabric edge is hemmed
while rolling it under.
Used for finishing bottom
of shirts and blouses and
Cut away a corner of fabric in order to make
edges of frills and hand-
work easier.
kerchiefs.
Insert fabric into spiral groove in hemmer foot
until needle position is reached.
CAUTION:
Make sure to turn
off the machine
before changing
the presser foot.
23
All manuals and user guides at all-guides.com
Remove presser foot holder.
Presser bar
Presser foot clamp screw
Remove presser foot holder.
0.5cm
Fabric
10cm Groove
2.
Attach even feed foot to machine.
Presser foot
clamp screw
Put forked section of actuating lever around
needle clamp, attach to presser bar and se-
curely tighten presser foot clamp screw.
* Sewing speed should be set at low to me-
dium.
2.
Attach even feed foot to machine.
0.8cm
Drawing ends of needle and bobbin threads,
turn handwheel 3 or 4 turns by hand to guide
fabric to hemmer foot.
Actuating lever
Needle
clamp screw