Table of Contents
Advertisement
https://appliancetechmanuals.com
Home Topload Washers
Refer to Page 7 for Model Numbers
Original Instructions
Keep These Instructions for Future Reference.
TLW24C_SVG2
CAUTION: Read the instructions before using the machine.
(If this machine changes ownership, this manual must accompany machine.)
Part No. 204666ENR2
www.alliancelaundry.com
July 2020
Advertisement
Table of Contents
Troubleshooting
Subscribe to Our Youtube Channel
Related Manuals for Alliance Laundry Systems AWN43RSN115CW01
Summary of Contents for Alliance Laundry Systems AWN43RSN115CW01
- Page 1 https://appliancetechmanuals.com Home Topload Washers Refer to Page 7 for Model Numbers Original Instructions Keep These Instructions for Future Reference. TLW24C_SVG2 CAUTION: Read the instructions before using the machine. (If this machine changes ownership, this manual must accompany machine.) Part No. 204666ENR2 www.alliancelaundry.com July 2020...
- Page 2 https://appliancetechmanuals.com...
-
Page 3: Table Of Contents
Adjustments..................33 © Copyright 2020, Alliance Laundry Systems LLC All rights reserved. No part of the contents of this book may be reproduced or transmitted in any form or by any means without the expressed written consent of the publisher. - Page 4 Leveling Legs....................33 Belt......................33 Drive Bell Torque..................33 Cycle Sequence Charts................34 Normal Eco Cycle..................34 Non-Eco Cycles....................34 Cycle Values....................35 Agitation Levels................... 36 Keys......................36 © Copyright, Alliance Laundry Systems LLC - Part No. 204666ENR2 DO NOT COPY or TRANSMIT...
-
Page 5: Safety Information
W007 © Copyright, Alliance Laundry Systems LLC - Part No. 204666ENR2 DO NOT COPY or TRANSMIT... -
Page 6: Locating An Authorized Service Person
Locating an Authorized Service Person Alliance Laundry Systems is not responsible for personal injury or property damage resulting from improper service. Review all service information before beginning repairs. Warranty service must be performed by an authorized technician, using authorized factory parts. -
Page 7: Introduction
Information in this manual is applicable to these washer models: AWN43RSN115CW01 AWN63RSN115CW14 AWN43RSN115CW14 AWN63RSN115TW01 AWN43RSN115TW01 AWN63RSN115TW0P AWN43RSN116TW01 AWN63RSN116TW01 AWN43RSN305LW01 ZWN43RSN115CW01 AWN43RSN305NW29 ZWN43RSN116CW01 AWN43RSN305XW01 ZWN63RSN115CW01 AWN63RSN115CW01 ZWN63RSN116CW01 © Copyright, Alliance Laundry Systems LLC - Part No. 204666ENR2 DO NOT COPY or TRANSMIT... -
Page 8: How Your Washer Works
While water hose. The air pressure continues to increase as the washtub fills © Copyright, Alliance Laundry Systems LLC - Part No. 204666ENR2 DO NOT COPY or TRANSMIT... -
Page 9: Customer Service
Alliance Laundry Systems at (920) 748-3950 for the name and address of the nearest authorized parts distributor. For technical assistance, call (920) 748-3121. © Copyright, Alliance Laundry Systems LLC - Part No. 204666ENR2 DO NOT COPY or TRANSMIT... -
Page 10: Troubleshooting Diagnostics
Hot, Cold Unlocked 2 and then 1 Pressure Sen- sor Fill Lid Lock None Locked 7 and then 1 Lid Lock Check Table 1 continues... © Copyright, Alliance Laundry Systems LLC - Part No. 204666ENR2 DO NOT COPY or TRANSMIT... - Page 11 Exit when temperature reaches 104°F [40°C] Exit when machine unpowered Exit when step timed out Table 2 Exit when lid locks Exit when overflow level is reached Table 2 continues... © Copyright, Alliance Laundry Systems LLC - Part No. 204666ENR2 DO NOT COPY or TRANSMIT...
- Page 12 When the Switch is On, the SPIN LED (and EXTRA RINSE LED, if applicable) will be lit. Press Start/Pause button with Extra Rinse off to exit the step. © Copyright, Alliance Laundry Systems LLC - Part No. 204666ENR2 DO NOT COPY or TRANSMIT...
-
Page 13: Advance To Drain And Spin
SPIN LEDs are on and the machine enters a Delicate Cycle Short How to Advance: agitate. 1. Make sure EXTRA RINSE is in the OFF position. © Copyright, Alliance Laundry Systems LLC - Part No. 204666ENR2 DO NOT COPY or TRANSMIT... -
Page 14: Feature Configuration - Through Serial Nos. Beginning 1810
Switch 5: When Pausing Allowed, Rapid Advance Disabled (Off) is selected, pressing the Start/Pause button during Run Mode will pause the cycle. When Rapid Advance Enabled (On) is selected, © Copyright, Alliance Laundry Systems LLC - Part No. 204666ENR2 DO NOT COPY or TRANSMIT... -
Page 15: Mixing Valve Solenoid Test
8. Run washer through a cycle to verify proper operation. TLW1890B_SVG 1. Lock tab is at 12 o’clock position. (Note: Tab is colored white for illustration purposes) Figure 3 © Copyright, Alliance Laundry Systems LLC - Part No. 204666ENR2 DO NOT COPY or TRANSMIT... -
Page 16: Error Codes
On control software version 4 and lower. Drive belt is sensed as LOCK 2 times broken or has fallen off. Replace belt. If belt is not broken, re- place front end control. Table 10 continues... © Copyright, Alliance Laundry Systems LLC - Part No. 204666ENR2 DO NOT COPY or TRANSMIT... - Page 17 Unpower to clear error. Check voltage input to machine. If it happens only at start of spin, replace motor. Replace drive board if error persists. Table 10 continues... © Copyright, Alliance Laundry Systems LLC - Part No. 204666ENR2 DO NOT COPY or TRANSMIT...
- Page 18 All LEDs continu- Over Current Shunt Detection Circuit Fail Hardware failure. Unpower to clear error. Replace drive board if Error at Startup error persists. Table 10 continues... © Copyright, Alliance Laundry Systems LLC - Part No. 204666ENR2 DO NOT COPY or TRANSMIT...
- Page 19 All LEDs continu- Unbalance Switch Error Hardware failure. Check unbalance switch and wiring. Unpower to clear error. Replace drive board if error persists. Table 10 © Copyright, Alliance Laundry Systems LLC - Part No. 204666ENR2 DO NOT COPY or TRANSMIT...
-
Page 20: Troubleshooting Flowcharts
Refer to the washer's serial plate to determine proper voltage it is designed to operate on. Refer to Figure 2 for serial plate location. © Copyright, Alliance Laundry Systems LLC - Part No. 204666ENR2 DO NOT COPY or TRANSMIT... -
Page 21: No Hot Water
Is there proper voltage (refer to serial plate) output Replace output board. from output board to the mixing valve hot solenoid? © Copyright, Alliance Laundry Systems LLC - Part No. 204666ENR2 DO NOT COPY or TRANSMIT... -
Page 22: No Cold Water
Is there proper voltage (refer to serial plate) output Replace output board. from output board to the mixing valve cold solenoid? Is cold solenoid Replace valve. inoperative? © Copyright, Alliance Laundry Systems LLC - Part No. 204666ENR2 DO NOT COPY or TRANSMIT... -
Page 23: No Warm Water
WASH, RINSE STATUS lights flash 1 or 2 times No Hot Refer to Is there no hot water? Water flowchart. Is there no cold Refer to No Cold water? Water flowchart. © Copyright, Alliance Laundry Systems LLC - Part No. 204666ENR2 DO NOT COPY or TRANSMIT... -
Page 24: Slow Hot Fill Or Warm Fill Is Too Cold
Check water pressure. Is water pressure too Recommended water low? pressure is 20 to 120 psi. Unit is filling properly. Refer to note above. © Copyright, Alliance Laundry Systems LLC - Part No. 204666ENR2 DO NOT COPY or TRANSMIT... -
Page 25: Water Fill Does Not Stop At Proper Level
Install 562P3 Siphon washer during cycle Break Kit. due to end of drain hose being lower than cabinet top of washer? © Copyright, Alliance Laundry Systems LLC - Part No. 204666ENR2 DO NOT COPY or TRANSMIT... -
Page 26: Pressure Sensor Error
Replace pressure sensor harness sensor harness. damaged? If Pressure Sensor error is still displayed, then replace pressure sensor. If problem persists, replace front end control. © Copyright, Alliance Laundry Systems LLC - Part No. 204666ENR2 DO NOT COPY or TRANSMIT... -
Page 27: Slow Spin Or No Spin
Replace lock. Is drive belt broken Replace belt or loose? Check wiring from drive board to motor Motor won't run? and review error codes. © Copyright, Alliance Laundry Systems LLC - Part No. 204666ENR2 DO NOT COPY or TRANSMIT... -
Page 28: Washer Is Locked Up Or Binding
Washer Is Locked Up Or Binding Are there clothes Remove clothes and stuck between tubs? retest. Is there a bind in upper or lower Replace bearings. bearing? © Copyright, Alliance Laundry Systems LLC - Part No. 204666ENR2 DO NOT COPY or TRANSMIT... -
Page 29: Outer Tub Does Not Empty
Replace pump. serial plate) present at pump? Is wiring from pump Correct wiring. Refer to drive board to appropriate wiring broken, loose or diagram. incorrect? © Copyright, Alliance Laundry Systems LLC - Part No. 204666ENR2 DO NOT COPY or TRANSMIT... -
Page 30: Excessive Vibration
Relocate washer or on weak, \"spongy\", support floor to Is friction ring Replace friction ring. carpeted or built-up eliminate weak or broken? floor? \"spongy\" condition. © Copyright, Alliance Laundry Systems LLC - Part No. 204666ENR2 DO NOT COPY or TRANSMIT... -
Page 31: Water Leaking From Outer Tub
Replace gasket. gasket leaking? Is water coming out of overflow holes in upper tub cover due Level washer. to out tub leaning back or not level? © Copyright, Alliance Laundry Systems LLC - Part No. 204666ENR2 DO NOT COPY or TRANSMIT... -
Page 32: Lid Does Not Lock
Are all lid bumpers Replace bumpers. in place? Is wiring to lid lock Repair or reconnect broken or harness. disconnected? © Copyright, Alliance Laundry Systems LLC - Part No. 204666ENR2 DO NOT COPY or TRANSMIT... -
Page 33: Adjustments
Adjustable Rear Leg Extension Kit is available as optional equipment at extra cost. TLW2286N_SVG 1. Level 2. Locknut 3. Leveling Leg 4. Rubber Foot 5. Washer Base Figure 5 © Copyright, Alliance Laundry Systems LLC - Part No. 204666ENR2 DO NOT COPY or TRANSMIT... -
Page 34: Cycle Sequence Charts
Deep Spin Rinse Rinse Fill 4:00 Cold + Hold Rinse Agitate 3:00 Refill Hold Final Extract 9 Spin Extract 14:30 Evacuate Spray Spin Table 12 © Copyright, Alliance Laundry Systems LLC - Part No. 204666ENR2 DO NOT COPY or TRANSMIT... -
Page 35: Non-Eco Cycles
Deep Spin Rinse * Rinse Fill 3:30 Cold + Hold Rinse Agitate 3:00 Refill Hold Final Extract 9 Spin Extract 10:00 Evac High Spin Table 13 © Copyright, Alliance Laundry Systems LLC - Part No. 204666ENR2 DO NOT COPY or TRANSMIT... -
Page 36: Cycle Values
Medium Cold values are on Table 15 If Extra Rinse is selected on a Spin Only Cycle, then Speed will be 20 RPM during fill © Copyright, Alliance Laundry Systems LLC - Part No. 204666ENR2 DO NOT COPY or TRANSMIT...
Need help?
Do you have a question about the AWN43RSN115CW01 and is the answer not in the manual?
Questions and answers