Hurco VM Series Maintenance And Safety Manual page 4

Every 3 Months (Every 500 Hours or as stated)

Check the ATC oil level. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 - 9

Drain moisture from the lines of the FRL. . . . . . . . . . . . . . . . . . . . . . . . . . 3- 23

Replace coolant and coolant filters. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3- 25

Replace the CTS coolant filter (if equipped). . . . . . . . . . . . . . . . . . . . . . . . 3- 26

Clean the chip conveyor tank (if equipped).

Measure the ground impedance (resistance to true earth). . . . . . . . . . . . . . 3- 29
Every 6 Months (Every 1000 Hours or as stated)

Grease the ATC magazine chain assembly . . . . . . . . . . . . . . . . . . . . . . . . . 3 - 9

Verify the machine is sitting level. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3- 29
Annually (Every 2000 Hours or as stated)

Clean the autolube reservoir tank and suction filter. . . . . . . . . . . . . . . . . . . 3 - 8

Replace the ATC oil. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 - 9

Flush, clean, and refill the spindle chiller tank (if equipped).. . . . . . . . . . . . . 3- 15

Replace the rotary-axis oil (if equipped). . . . . . . . . . . . . . . . . . . . . . . . . . . 3- 31

Replace the tilt-axis oil (if equipped). . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3- 32
iv - VM Maintenance Checklist
. . . . . . . . . . . . . . . . . . . . . . . 3- 27
704-0212-209
VM Series Maintenance and Safety Manual