Functions; Aspect Switching; A/V Center/Monitor Composite Signal Input; Display Aspect - Hitachi ULTRAVISION UT32S402 Operating Manual

FUNCTIONS

Aspect Switching

Each time the button of the remote control is pressed, the screen display aspect
ASPECT
is switched in sequence, and the status will be displayed at the bottom of the screen.

A/V Center/Monitor Composite Signal Input

Display Aspect

Watching Standard Definition Pictures 4:3(Analog/Digital TV, Composite, Component, HDMI*)
4:3 16:9
Expanded
Watching Standard Definition Pictures 16:9(Digital TV, Component, HDMI*)
16:9
Zoom 1
Expanded
Watching High Definition Pictures (720p, 1080i, 1080p)(Digital TV, Component, HDMI*)
16:9
Zoom 1
Real
Expanded
You can display the image at its optimum condition by selecting display aspect depending on the current output
image as shown below.
Display
Input Signal
Screen
When Watching Standard Definition Pictures 4:3:
(4:3 Signal)
When Watching Standard Definition Pictures 16:9:
(16:9 Signal)
Zoom 1
Zoom 2
Display
Aspect
4:3
16:9
Zoom 1
Zoom 2
Expanded
16:9
Zoom 1
Expanded
Aspect button
To display suitable screen as follows.
Plays a 4:3 image on screen faithfully. Blanking occurs on
both sides.
Plays a 4:3 image which enlarges horizontal and vertical size of
the middle in equal scales, and displays both sides appearing
much wider.
Use these aspect modes to zoom in on conventional (4:3)
sources.
Use these aspect modes to zoom in on conventional (4:3)
sources further more than Zoom 1.
Use this aspect mode to display conventional (4:3) sources
by linearly increasing image expansion from the center
towards the edges of the display area in order to fill it.
*HDMI doesn't support Expanded
Plays a 16:9 image faithfully showing 95% of the size.
Use this aspect to Zoom-in once while in 16:9 aspect.
Use this aspect mode to display (16:9) sources by linearly
increasing image expansion from the center towards the
edges of the display area.
*HDMI doesn't support Expanded
42