Troubleshooting; About Lcd Display Technology; When The Following Messages Appear On The Screen; Symptom And Checklist - Hitachi ULTRAVISION UT32S402 Operating Manual

1.5™ ultrathin lcd television
Table of Contents

Advertisement

TROUBLESHOOTING

About LCD Display Technology

The following are common phenomena occurring when viewing LCD display devices due to its characteristics.
Please note that these are not malfunctions.
Defective Spots on Panel
The LCD panel is manufactured with high-precision technology. However, there might be some spots that are not
illuminated, or are brighter than others, or are in different colors, etc.
Surface on Panel
The LCD panel displays images by the fluorescent lamps internally. This can raise the temperature of the display
surface.
In addition, do not allow any heavy impact to the front of the panel because the LCD panel is made of high precision
glass.
Use Under Low Temperature Conditions
Because of the structural characteristics of the LCD panel, the response speed of the LCD panel becomes slower
when the ambient temperature becomes too low. In some cases, this may result in a residual image.
The residual image will disappear of its own accord as the temperature rises again to a normal level.
Before calling a service technician, check the following tables first. If the problem cannot be solved with the
suggested procedures, contact 800-HITACHI. For your safety, NEVER try to repair the product yourself.

When the Following Messages Appear on the Screen

Message
Power Save
No Sync. Signal
Invalid Scan Freq.
Not Available
Weak Signal or Channel not
available.
Auto Adjusting

Symptom and Checklist

Symptoms
No picture - no sound
Multiple images-normal sound
45
Condition / Action
This indicates it is in Power Save mode. (in Monitor Composite/RGB mode)
This message appears 5 seconds before Power Save mode starts.
The indicating lamp lights in orange.
The unit cannot detect any signals from any input terminals.
Check if the cable is connected correctly and firmly.
Check if the power of any external equipment is ON.
Check if the input selection matches the connection terminal.
Check if the PC is in Power Save mode or not.
The unit receives unsupported signals.
Check if the cable is connected correctly and firmly.
Check if the input signal is compatible with the specification of the monitor.
This shows when the selected operation is not available.
This shows the selected channel is not available.
Check the signal meter on A/V Center OSD.
This indicates that it is in the process of auto adjusting. (in RGB mode)
Check if the power of the A/V Center and UT Monitor or
external equipment is ON.
Check the connection of the power cord and/or other cables.
Check if the correct mode is selected.
Check if the UT Monitor is in "Standby mode" or "Power Save
mode".
Adjust the values in "Picture" and "Audio" on UT Monitor
menu".
Check the connections to external equipment.
Checklist
Page
44
~
20
23
44
48
,
50
41
Page
~
20
24
26
,
46
20
~
23

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents