Table of Contents
Advertisement
Pin Signal
1
Audio output B (right)
2
Audio input B (right)
3
Audio output A (left)
4
Ground (audio)
5
Ground
6
Audio input A (left)
7
-
Function select (AV control)
8
9
Ground
10
-
11 -
12
-
13 Ground (Chrominance)
14 Ground (blanking)
15 Chrominance input
-
16
17 Ground video (input &output)
18 Ground video (input &output)
19
Video output (composite)
20 Video input (composite)
/Luminance input
21
Common ground (shield)
Notes: composite Video input of SCART1 can not output by SCART1 and SCART3.
Notes: Y/C can not be displayed in the PIP source.
Cleaning and care
WARNING: Do not try to remove the cabinet back. Refer servicing to qualified service technicians.
To clean the TV screen:
1) Unplug the TV to avoid possible shock hazard.
2) Use a clean cellulose sponge or chamois cloth dampened with a solution of mild detergent and warm
water to clean the TV screen and trim. Do not use too much water as water spilled into the cabinet
can cause damage to the TV.
3) Wipe off any excess moisture with a clean dry cloth.
4) Polish the cabinet with a quality furniture polish to maintain the finish and appearance of the cabinet.
Caution: Never use strong solvents such as thinner, benzene, or other chemicals on or near the cabinet.
These chemicals can damage the finish of the cabinet.
SCART arrangement 3
Signal level
0.5V rms
0.5V rms
0.5V rms
-
-
0.5V rms
-
High (9.5-12V) - AV mode
Mid(5-8V)-Wide-screen
Low (0-2V) - TV mode
-
-
-
-
-
-
0.3V
-
-
-
1V including sync
1V including sync
-
-19 -
Impedance
<1kohm
>10kohm
<1kohm
-
-
>10kohm
-
>10kohm
-
-
-
-
-
-
75ohms
-
-
-
75ohms
75ohms
-
Advertisement
Table of Contents
