Adjusting The Airflow Direction - Hisense KFR 2601GW/BPE Instruction Manual

Adjusting the Airflow Direction

1. Horizontal
!
CAUTION
2. Vertical
A.Sweep function
The flap starts moving up and down to
deliver air over the sweep range.
!
NOTE
!
CAUTION
The horizontal airflow can be adjusted by moving the vertical vanes wit your hands to the
left or right.
When the humidity is high, the vertical vanes should be in the front
position during the cooling or dehumidifying operation. If the vertical
vanes are positioned all of the way to the right or left, condensation may
begin to form around the air vent and drip down.
The vertical airflow can be adjusted by moving the flap with the remote control unit has
been turned on. Then, use the FLAP button to set either the sweep function or one of
the six airflow direction settings.
FLAP
FAN
ON OFF
SPEED
SET CLR SOFT
BATTERY
A/C SENSOR
¡ñThe flap automatically closes when the unit is off.
¡ñ
Use the FLAP button on the remote control to adjust the position of the flap.
If you move the flap by hand, the flap position according to the remote control
and the actual flap position may no longer match.If this happens,shut off the
unit, wait for the flap flap to close, and then turn on the unit again; the flap
position will now be normal again.
¡ñ Do not have the flap pointed down during cooling operation. Condensation
May begin to from around the air vent and drip down.
MODE
SLEEP
SWEEP
ACL
B.Automtic Function
The flap moves up and down automatically
from to
operation, from
operation. Referring to the above illustration.
11
6
5
COOL
and
DRY
4
3
2
1
HEAT
during the cooling or drying
to duing the heating