Kärcher NT 70/1 Manual page 14

General
Caution
The cartridge filter must never be removed
during vacuuming.
When the dirt water reaches the highest
–
permissible level in the container, the
suction power is interrupted.
After having completed the wet vacuum
–
operation clean the cartridge filter, the
mechanical overflow safeguard and the
container and let dry.
If you change immediately from wet to
–
dry vacuuming, then replace the wet
cartridge filter with a dry one.
Clip connection
Illustration
The suction hose is equipped with a clip
system. All C-40/C-DN-40 accessories can
be connected.
Operation
Turning on the Appliance
 Plug in the main plug.
 Turn on the appliance.
Turn off the appliance.
 Turn off the appliance.
 Pull out the mains plug.
After each operation
 Empty the container.
 Vacuum and wipe the appliance inside
and outside.
Storing the Appliance
 Wind the suction hose and the mains ca-
ble and hang it over the pushing handle.
 Place the appliance in a dry room and
secure it from unauthorized use.
14
Caution
Risk of injury and damage! Observe the
weight of the appliance when you transport it.
 Remove the suction pipe with the floor
nozzle from the holder. Hold the appli-
ance by the handle and at the suction pipe
to transport it, not by the push handle.
 Pull the device behind you at the carry-
ing handle for transporting it over longer
distances
 When transporting in vehicles, secure
the appliance according to the guide-
lines from slipping and tipping over.
Caution
Risk of injury and damage! Note the weight
of the appliance in case of storage.
This appliance must only be stored in inte-
rior rooms.
Maintenance and care
Danger
First pull out the plug from the mains before
carrying out any tasks on the machine.
Change cartridge filter
 Release and remove the suction head.
 Unscrew the star screw, pull out the car-
tridge filter and replace with a new one.
 Tighten the star screw.
 Insert and lock the suction head.
Cleaning the mechanical overflow
 Release and remove the suction head.
 Unscrew the star scew and pull out the
cartridge filter.
 Clean the mechanical overflow safe-
guard
 Replace the cartridge filters.
 Tighten the star screw.
 Insert and lock the suction head.
– 3
EN
Transport
Storage
safeguard