Aligning Fence Parallel To Miter Slot; Aligning Fence Perpendicular To The Table; Dust Collection - Delta 36-725 T2 Instruction Manual

ALIGNING FENCE PARALLEL TO
MITER SLOT
1.
Move fence adjacent to right miter gauge slot and secure
to the guide tube by lowering the fence clamping lever.
2.
If the fence face , Figure 34, is not parallel to the miter
A
slot , raise the clamping lever and lift the fence and
B
place it on the saw table.
3.
Adjust one or both of the set screws
4.
Replace fence on guide tube and verify the fence is parallel
to the miter slot. If fence is closer to parallel, turn the set
screw in the same direction but a little less. If the fence is
further out of parallel, turn the set screw in the opposite
direction.
ALIGNING FENCE
PERPENDICULAR TO THE TABLE
1.
Move fence over the cast iron table and secure to the guide
tube by lowering the fence clamping lever.
2.
Use a square to check that the fence face is perpendicular
to the table.
3.
If the fence face is not perpendicular to the table, release
the clamping lever and slightly adjust one of the slotted set
screws , Figure 35, until the fence face is perpendicular
A
to the table.
4.
Secure the fence to the guide tube to insure the fence
remains perpendicular. If not, repeat steps 1 through 3.

DUST COLLECTION

1.
Connect a 2 1/2 inch shop vacuum or dust collection hose
to dust port on back of saw for best dust collection. See
Figure 36.
MAKING ADJUSTMENTS
1/4 turn or less.
C
25
C
B
Figure 34
Figure 35
Figure 36
A
A