Aligning Fence Parallel To Miter Slot; Aligning Fence Perpendicular To The Table - Delta 36-725 T2 Instruction Manual

ALIGNING FENCE PARALLEL TO
MITER SLOT
1.
Move fence adjacent to right miter gauge and secure to the
guide tube by lowering the fence clamping lever.
2.
If the fence face (A) figure 42, is not parallel to the miter
slot (B), raise the clamping lever and lift the fence and
place it on the saw table.
3.
Adjust the one or both of the set screws (C) 1/4 turn or
less.
4.
Replace fence on guide tube and repeat steps 1 through
3. If fence is closer to parallel, turn the set screw in the
same direction but a little less. If the fence is further out of
parallel, turn the set screw in the opposite direction.
5.
Repeat steps 1 through 3.
ALIGNING FENCE
PERPENDICULAR TO THE TABLE
1.
Move fence over the cast iron table and secure to the guide
tube by lowering the fence clamping lever.
2.
Use a square to check that the fence face is perpendicular
to the table.
3.
If the fence face is not perpendicular to the table, release
the clamping lever and slightly adjust one of the slotted set
screws (A) figure 43 until the fence face is perpendicular to
the table.
4.
Secure the fence to the guide tube to insure the fence
remains perpendicular. If not, repeat steps 1 through 4.
Auxiliary Fence
For thin materials use the fence on the left of the blade. Fold
down the thin fence to allow use of blade guard. Subtract 2
inches from the scale for accurate measurement.
FIGURE 40
ALIGNMENT
C
B
Dust Collection
1.
Connect a shop vacuum or dust collection hose to dust port
on back of saw for best dust collection.
29
A
FIGURE 38
A
FIGURE 39
FIGURE 41