Speaker Test - Axis C1004-E User Manual

AXIS C1004-E Network Cabinet Speaker
The device interface
Audio site security
CA certificate: Select the certificate to use when you add devices to the audio site when TLS authentication is enabled in
AXIS Audio Manager Edge.
Save: Click to activate and save your selection.

Speaker test

You can use the speaker test to verify from a remote location that the speaker works as intended.
Calibrate: Click to calibrate the speaker before you test it for the first time. During calibration, the speaker plays a series
of test tones that are registered by the built-in microphone. When you calibrate the speaker, it must be installed in it's final
position. If you move the speaker later on, or if it's surroundings change, for example if a wall is built or removed, you need
to recalibrate the speaker.
Run the test: Click to play the same series of test tones that were played during calibration, and compare them with the
registered values from the calibration.
Recordings
Click to filter the recordings.
From: Show recordings done after a certain point in time.
To: Show recordings up until a certain point in time.
Source : Show recordings based on source.
Event: Show recordings based on events.
Storage: Show recordings based on storage type.
Click to play the recording.
Click to stop the recording.
Click to show more information and options about the recording.
Set export range: If you only want to export part of the recording, enter from when to when.
Click to delete the recording.
Export: Click to export (part of) the recording.
15