Table of Contents
Advertisement
Programming GPIO Inputs
The Image Server has six General Purpose Inputs, referred to as GPI 1 through GPI 6. Each GPI can
be programmed to trigger one of the following events on a channel.
CUE
JUMP
NEXT
PAUSE
PLAY
RECORD
SELPREV
SELNEXT
STOP
To program a GPIO Input, select EDIT->CONFIGURE->GPI. The screen of Figure 12 is displayed.
GPI 1 through 6 are the 6 programmable inputs. The checkboxes to the right of each selection
represent channel 1, 2 and 3. GPI 5 is shown with the trigger option pulldown expanded.
To activate one of the GPI, check the checkbox for the channels of interest, then pulldown the event
menu and select which event will be triggered when the GPI goes active. Click APPLY to activate.
Image Server 2000 Owner's Manual
All manuals and user guides at all-guides.com
Cue a clip
Cue selected clip for immediate playback (Playlist Mode only)
Prepare next clip in a playlist for playback (Playlist Mode only)
Pause a clip
Play a clip
Start a recording
In Playlist Mode – Navigate to clip above currently selected clip
In Playlist Mode – Navigate to clip below currently selected clip
Stop a clip
Figure 12 - GPI Configuration Screen
Page 47
Advertisement
Table of Contents
