Advertisement
Quick Links
POWER STEEL™
RECTANGULAR POOLS
OWNER'S MANUAL
Para la instrucción en español,
visite bestwaycorp.com/support
Visit Bestway YouTube channel
WE SUGGEST NOT TO RETURN
THE PRODUCT TO THE STORE
QUESTIONS? PROBLEMS?
MISSING PARTS?
For FAQ, Manuals, Videos Or
Spare Parts, Please Visit
bestwaycorp.com/support
Advertisement
Related Manuals for Bestway POWER STEEL B56631
Summary of Contents for Bestway POWER STEEL B56631
- Page 1 WE SUGGEST NOT TO RETURN THE PRODUCT TO THE STORE QUESTIONS? PROBLEMS? MISSING PARTS? For FAQ, Manuals, Videos Or Spare Parts, Please Visit bestwaycorp.com/support POWER STEEL™ RECTANGULAR POOLS OWNER’S MANUAL Para la instrucción en español, visite bestwaycorp.com/support Visit Bestway YouTube channel...
- Page 2 WARNING smooth out the bottom Put 1in. to 2in. water in the pool to cover the floor. Once pool floor is slightly covered, gently smooth out all wrinkles. Start in the center of the pool and work your way clockwise to the outside. Do not assemble on soft lawn.
-
Page 3: Electrocution Risk
WARNING Be Prepared to Respond to an Emergency: Keep a working phone and list of emergency numbers near pool. Become certified in cardiopulmonary resuscitation (CPR) so you can IMPORTANT SAFETY INSTRUCTIONS respond to an emergency. Read and Follow All Safety Information and Electrocution Risk: Instructions. - Page 4 should be located at least 54 inches above the threshold of the The pool shall be located a minimum distance of 6 ft. (1.83 m) from door. any electrical receptacle. All 125 volt, 15 and 20 ampere receptacles located within 20 ft. (6.0 m) (b) The pool should be equipped with a power safety cover which of the pool shall be protected by a ground fault circuit interrupter complies with ASTM F1346-91 listed below.
- Page 5 times. If the vertical leg or the U-support starts to sink into the ground, drain the water immediately to avoid the pool collapsing due to the uneven loading on the frame structure. Change the location of the pool or modify the surface material. 3.
- Page 6 STRUCTURE 21 ft. x 9 ft. x 52 in. (6.40 m x 2.74 m x 1.32 m) Before assembling your pool, please take a few minutes to check all the parts and become familiar with their position. NOTE: Drawing for illustration purpose only. May not reflect actual product.
-
Page 7: Installation
Talcum Powder before assembly. Talcum Powder is not included and easily available in the market. Bestway will not be responsible for damage caused to the pool due to mishandling or failure to follow these instructions. 1. Lay out all parts and check that you have the correct quantities as listed in the components list. -
Page 8: Pool Maintenance
FILLING POOL WITH WATER 4.7in.-7.9in. ATTENTION: (12cm-20cm) Do not leave pool unattended while filling with water. 1. Fill the pool until the water reaches the welding line located 4.7in.-7.9in. (12cm-20cm) from the top of the pool. DO NOT OVERFILL as this could cause the pool to collapse. In times of heavy rainfall you may need to empty some of the water to ensure the level is correct. - Page 9 NOTE: Damage resulting from chemical imbalance is not covered by the warranty. Pool chemicals are potentially toxic and should be handled with care. There are serious health risks from chemical vapors and the incorrect labeling and storage of chemical containers. Please consult your local pool supply retailer for more information about chemical maintenance.
- Page 10 Distributed in Australia & New Zealand by Bestway Australia Pty Ltd, Unit 2/98-104 Carnarvon St Silverwater, NSW 2128, Australia Tel: Australia: (+61) 29 0371 388; New Zealand: 0800 142 101 Distributed in United Kingdom by Bestway Corp UK Ltd. 8 Wentworth Road, Heathfield Industrial Estate, Newton Abbot, Devon, TQ12 6TL Exported by/Exporté par/Exportado por/Exportiert von/Esportato da Bestway (Hong Kong) International Ltd./Bestway Enterprise Company Limited...
Need help?
Do you have a question about the POWER STEEL B56631 and is the answer not in the manual?
Questions and answers