Brother STAR240E Service Manual page 30

89. Lower the presser lifter and install the rear cover and handle with the four screws (two on the front, one on
the rear and one on the bottom).
90. Install the front cover with the six screws (three on the rear side, two on the bottom, and one on the left
side).
91. Install the surface plate with the screw.
92. Install the flat bed attachment.
Assembly Points
90. Pass the thread tension assembly and feed bracket assembly dial and Zigzag dial through the hole in the
front cover and fit the front cover in place from above. At this time, make sure that the pattern selected
with the selection dial and the pattern displayed on the front cover match. Install with the front cover
pattern display and the selection unit set to Pattern No. 1 (STAR240E, STAR230E, PS57, PS55), No. 3
(PS53).
www.promelectroavtomat.ru
-28-