Table of Contents
Advertisement
G-Sensor
All I-Series 4 Slate units are equipped with a g-sensor and will rotate the video based on the orientation of the device.
Debug Bridge (ADB) control (Developers Only)
Connecting to ADB
Elo device supports debugging via Wi-Fi/Ethernet or using the a separate microUSB cable(not included)
Set I-Series 4 Slate to (Developer)
•
Enter
Settings → About Phone → Build Number.
•
Tap Build Number 7 times to enter developer mode.
Go back to the
•
•
From Developer options on- screen display, enable the option called "USB debugging".
To connect via Wi-Fi
Ensure that your computer is online and not behind a firewall.
•
Find the IP address (by going to
•
On your host computer, use the command ADB connect <IP address> to be able to perform ADB actions.
To connect via USB
Locate the debug port on the USB-C Head as shown in the figure below.
This will require removing the head from the stand
Remove Rubber Plug and plug in MicroUSB Cable
User Manual –I-Series 4 Slate
Settings → System → Advanced and you will see "Developer Options".
Settings → Network & Internet → Wi-Fi →Tap the active connection → Advanced→ IP Address.
UM600587 Rev A page 69 of 81
Advertisement
Table of Contents
