Connecting The Water Supply; Connecting The Exhaust Duct; Adjusting The Feet - Beko BDFN Series Manual

Connecting the water supply

We recommend installing a filter
at the water inlet to prevent dirt
(sand, clay, rust) from your
home's water network or
installation from damaging the
machine or the washing up.
Permissible water temperature:
up to 25°C (60°C for products
fitted with Aquasafe+; please
see Aquasafe+ section)
It is not recommended to connect
the dishwasher to open water
heaters or continuous flow water
heaters.
REMARK Do not use an old or used
water inlet hose with your new
product. Use the new water inlet hose
supplied with the product. Do not add
an extension to the pipes.
REMARK Connect the water inlet hose
directly to the water tap. The pressure
from the valve must be 0.3 bar
minimum and 10 bar maximum. If the
water pressure is higher than 10 bar,
a pressure relief valve must be fitted
in the middle.
REMARK Water supply and drain
hoses must be securely attached
and remain in good condition.
REMARK Fully open the taps after
making the connections to check for
water leaks.
Connecting the exhaust
duct
The water drain hose can be directly
connected to the drain pipe or the
sink drain. Refer to the installation
manual supplied with your machine
for detailed information.
The drain hose must be connected to
the sewer and must not be connected
to surface water.
Leg adjustment
If the product door cannot be closed
tightly or the product rocks when you
push it lightly, you need to adjust its
feet. Adjust the feet of the product as
shown in the installation manual
supplied with the product.
Steam may escape if the
dishwasher door is not adjusted
correctly. The hot steam could
cause serious burns and injuries,
and damage your furniture.
13/EN