Installation; Appropriate Installation Location - Beko BDFN Series Manual

4- Installation

First of all, read the section
" Safety instructions " !
Installation procedures should always be
performed by the manufacturer, an
authorized service agent or a qualified
person specified by the importer. To
make your machine ready for use, please
check that the electricity, drainage and
water supply system are adequate
before calling an authorized service. If
not, contact a qualified technician and
plumber to have the arrangements
necessary are taken.
The preparation of the location as
well as the electrical, water tap and
waste water installations at the
installation site are the responsibility
of the customer.
The installation and electrical
connections of the appliance must be
carried out by the authorized service
agent. The manufacturer will not be
held liable for damage resulting from
processes carried out by unauthorized
persons.
Before proceeding with the
installation, check whether the
product has any defects. If the
product is damaged, do not have it
installed. Damaged products pose
risks to your safety.
Check that the water inlet and
drain hoses are not kinked,
pinched, or crushed when
replacing the product after
installation or cleaning procedures.
The front of the unit cannot be
removed on freestanding models
or under countertops. In such a
case, the warranty will be void.
12/FR
When placing the appliance, be careful
not to damage the floor, walls, piping,
etc. Avoid moving the appliance by
holding it by the door or the panel.
Suitable installation
location
In the area where the product is
installed, there should be no
lockable, sliding or hinged doors
that would limit the full opening
of the product door.
Be sure to choose a location that
will allow you to load and unload
dishes quickly and comfortably.
•
Place the product on solid, level
ground with sufficient load-bearing
capacity! The appliance must be
installed on a flat surface so that the
door is closed correctly and securely.
•
Avoid installing the product in
places where the temperature is
likely to drop below 0 ºC.
•
Install the product on a hard floor.
Do not place the product on carpet
or similar surfaces.
Do not install the product on the
power cable.
•
Be sure to choose a location that
will allow you to load and unload
dishes quickly and comfortably.
•
Install the product in a location
close to the tap and drain pipe
Choose the location taking into
account that it cannot be changed
once the connections have been
made.