Operational Safety - Beko BDFN Series Manual

•
If the product is to be
placed inside a cabinet/
cupboard/module, be sure
keep the cabinet/
cupboard/module
doors open during the
operation in cases where
there are no openings to
ensure sufficient air
circulation.
Plug the product into a
grounded power outlet,
protected by a fuse
whose current ratings
comply with the product
nameplate. Have a
qualified electrician
perform the grounding
installation. Do not use
the product unless it is
properly grounded in
accordance with local/
national regulations.
Connect the product to an
outlet that complies with the
voltage and frequency values
indicated on the plate
product signage.
Do not plug the product
into outlets that are
loose, dislocated, broken,
dirty, greasy, or likely to
come in contact with
water, such as locations
where water may leak
from the plan of work.
REMARK You have to
use the new hose set supplied
with the product. Do not
reuse the old hose set. Do not
add an extension to the pipes.
REMARK plug it in
water inlet hose directly to the
water tap. The pressure from
the valve should be 0.03 MPa
(0.3 bar) minimum and 1 MPa
(10 bar) minimum.
maximum. If the water pressure
is higher than 1 MPa (10 bar), a
pressure relief valve must be
fixed in the middle.
Route the electrical cable
and hoses so that they
cannot trip over anyone.

Operational safety

• Only dishwasher-safe
detergents, rinse aids and
additives
can be used.
Never use chemical
solvents inside the
device. They carry a risk
of explosion.
The washing water
contained in the product is
not potable.
Dishwasher detergents
have a high alkali content
and can be very dangerous
when ingested. Avoid
letting them come into
contact with the skin and
eyes and hold them
7/EN