Beko BDFN Series Manual page 46

the salt scattered in the appliance. As the remaining salt granules under the lid
will be dissolved during the prewash and loosen the lid, check the lid again at the
end of the programme.
•
Water hardness setting is low or salt level is insufficient >>> Measure supply
water hardness and check water hardness setting.
•
The dishes are not sorted in order in the machine. >>> When placing the glasses and other
glass dishes in the basket, do not lean them against other dishes but against the corners or
supports of the basket or the support rod for the glasses. The impact of glasses with each
other or with other dishes due to the impact of water during washing can break them or
scratch their surface.
A film similar to a milk stain remains on the glasses and does not disappear
when wiped off with the hand. A bluish / rainbow appearance can be
distinguished when the glass is turned towards the light.
•
Too much rinse aid is used. >>> Reduce the rinse aid setting. Clean up rinse
aid that overflows when adding rinse aid.
•
Corrosion occurs on glass due to soft water. >>> Water hardness setting is
low or salt level is insufficient >>> Measure supply water hardness and
check water hardness setting. If your water is soft (<5dH), do not use salts.
Choose programs that wash at higher temperatures (eg 60-65°C). You can
also use commercially available glass cleaners.
Foam forms in the machine.
•
Dishes are hand washed with hand wash detergent but not rinsed before
being placed in the machine. >>>Hand dishwashing products do not contain
anti-foaming agents. It is not necessary to hand wash the dishes before
placing them in the machine. Removing the bulk of the dirt with a paper
towel or a fork is sufficient.
•
Rinse aid overflowed into machine when added. >>> Be careful not to
overflow the rinse aid into the machine when filling it. Clean up the spilled
product with a paper towel.
•
The lid of the rinse aid container is left open. >>> Make sure the rinse aid
reservoir lid is closed after adding rinse aid.
Kitchen utensils are broken.
•
The dishes are not sorted in order in the machine. >>> Load the dishes as
described in the user manual.
•
The baskets are overloaded. >>> Do not overload the baskets beyond their
capacity.
Water remains in the dishwasher at the end of the programme.
•
The filters are clogged. >>> Check if the filter system is clean. Periodically
clean the filter system as shown in the "Cleaning and Maintenance"
section.
46/EN