Pulse Output Module Spo01 - Toshiba V Series Manual

Pulse Output Module SPO01
SPO01 module specifications
Model name
Number of output points
Output insulation unit
Output signal
Resolution
Output type
Pulse direction
Output applied voltage
Output current
Leak current when output
is OFF
Voltage drop when output
is ON
Risetime
Address setting
Breakdown diagnosis
Insulation resistance
Ability of insulation to
withstand voltage
External power supply
External power supply
current comsumption
Current consumption
Internal heat generation
Compatible terminal block
units
Compatible options
Compatible I/O base unit
External dimensions
Weight
(Note 1) The setting by output type should be performed using the engineering tool. For the setting method,
see Chapter 2 " Registering Hardware " of the " Engineering Tool Manual " (6F8C1006).
Item
SPO01
4 points
The 4 points are isolated together
Open collector output
8 bit
Pulse width: Select either 72 or 9 ms (same setting for all points).
Pulse train: Select either 28 or 111 Hz (same setting for all points).
Open or close derection
13.5 - 26.4 Vdc
Resistance load: 100 mA/point (Max.)
Inductive load: 50 mA/point (Max.)
100  A or less
1 V or less (Resistance load: 100 mA)
20  s/10 - 90% or less (Resistance load: 100 mA)
Set from 1 to E (decimal 1 to 14) by front panel address setting switch.
External power supply voltage drop, transmission, CPU, memory,
Read-back check.
100 M  or more (measured with 500 Vdc megger, between total
outputs and internal circuits)
500 Vac for 1 minute (between total outputs and internal circuits)
24 Vdc  10% (21.6 to 26.4V), ripple 5% or less.
24 Vdc-15 mA or less
24 Vdc-100 mA or less (system power supply)
2.7 W or less (external 24 Vdc, all points output)
UTBA1
UABU1
40 W  90 H  95 D mm (excluding protrusions)
150 g or less
Specification
-
5. PI/O Module
143