Analog Output Module Sao06 - Toshiba V Series Manual

Analog Output Module SAO06
SAO06 module specifications
Model name
Number of output points
Output isolation unit
Output signal level
Load resistance range
Through-rate
D/A conversion data
CMRR
Standard output accuracy
Load fluctuation
Temperature drift
Supply voltage drift
Output ripple
Diagnosis of trouble
Dualization
Dualized switching condition
Output bump at dualized
switching
Address settings
Output specification in
emergency
Insulation resistance
Ability of insulation to withstand
voltage
Current consumption
Internal heat generation
Compatible terminal block unit
Compatible options
Compatible I/O base unit
Compatible communication
module
I/O bus transmission speed
External dimensions
Weight
(Note 1)Output specification when an error occurs can be set with the Engineering Tool. See Cahpter2,
" Registering Hardware " in the " Engineering Tool Manual (6F8C1006) " .
(Note 2) Read-back error occurs during output disconnecting.
Item
SAO06
8 points
8 points are isolated together (output (-) side common).
4-20 mAdc
0 to 600 
10 ms or less (0 to 90%, resistance load)
+800 to +4000 counts
100 dB or more (100 Vac-50/60 Hz)
Within  0.125% of full scale
Within  0.05% (250  standard)
Within  0.01%/  C
 0.1%/full-scale (system power supply variation  10%)
Within  0.5% of full scale
Output current lead-back(Note 2), transmission, CPU, memory
Possible (Two units are mounted on the UTBA6 terminal block
units.)
When a major alarm has occurred to the online module
Stabilized within 1ms (when the data output is constant)
Set from 1 to E (decimal 1 to 14) by front panel address setting switch.
When dualized, the pair is set for the same address.
HOLD mode (output hold) or RESET mode (output OFF) can be
selected.(Note 1)
100 M  or more (measured with 500 Vdc megger, between outputs
and internal circuits)
500 Vac for 1 minute (between Outputs and internal circuits)
24 Vdc-200 mA or less (system power supply)
4.8 W or less
UTBA1 (for single configuration), UTBA6 (for dualized configuration),
UTBA6 1(for dualized configuration),EC352AO0151(for single
configuration)
UABU1(for single configuration),UABU3(for dualized configuration)
SBIF2
375 kbps
40 W  90 H  95 D mm (excluding protrusions)
200 g or less
Specification
-
5. PI/O Module
125