Analog Output Module Sao01 - Toshiba V Series Manual

Analog Output Module SAO01
SAO01 module specifications
Model name
Number of output points
Output isolation unit
Output signal level
Load resistance range
Through-rate
D/A conversion data
CMRR
Standard output accuracy
Load fluctuation
Temperature drift
Power supply voltage drift
Output ripple
Output specification in
emergency
Address settings
Breakdown diagnosis
Insulation resistance
Ability of insulation to withstand
voltage
Current consumption
Internal heat generation
Compatible terminal block unit
Compatible options
Compatible I/O base unit
External dimensions
Weight
(Note 1)Output specification when an error occurs can be set with the Engineering Tool. See
Chapter2,"Registering Hardware" in the "Engineering Tool Manual (6F8C1006)" .
(Note 2) Read-back error occurs during output disconnecting.
Item
SAO01
8 points
8 points are isolated together (output (-) side common).
4-20 mAdc
0-750 
10 ms (0-63%)
+800 to +4000 counts
100 dB or more (100 Vac-50/60 Hz)
Within  0.125% of full scale
Within  0.05% (250 W standard)
Within  0.01%/  C
Within  0.1% of full scale (in a system with power supply
fluctuation of  10%)
Within  0.5% of full scale
HOLD mode (output hold) or RESET mode(output OFF) can
be selected. (Note 1)
Set from 1 to E (decimal 1 to 14) by front panel address setting
switch.
Output current lead-back(Note 2), transmission, CPU, memory
100 M  or more (measured with 500 Vdc megger, between
total outputs and internal circuits)
500 Vac for 1 minute (between total outputs and internal
circuits)
24 Vdc-300 mA or less (system power supply)
7.2 W or less (rated condition)
UTBA1
UABU1
40 W  90 H  95 D mm (excluding protrusions)
200 g or less
Specification
-
5. PI/O Module
119