Table of Contents
Advertisement
4.
tighten the hex nut on the fence handle
against the fence pivot block (figure 2).
pivot Block
Fence
handle
figure 2. Fence handle components.
5.
install the resaw fence lock handle (with the
8mm washer and moving plate) onto the
fence, then slide the resaw fence over the
moving plate as shown in figure 3.
note: Leave the moving plate and lock
handle loose enough to slide on the resaw
fence.
resaw Fence
resaw lock
handle
figure 3. example of attaching resaw fence to
standard fence.
6.
tighten the resaw lock handle.
7.
pull the fence handle up and place the fence
assembly on the rail.
8.
push the fence handle down to lock the fence
assembly in place.
-2-
hex nut
Moving
plate
test run
1.
Follow steps 1-3 in the g0636X Manual on
page 20.
2.
Verify that the machine is operating correctly
by turning the switch disabling key (figure 4)
to "1" and turning the machine ON.
—When operating correctly, the machine
runs smoothly with little or no vibration or
rubbing noises.
— investigate and correct strange or unusual
noises or vibrations before operating the
machine further. always disconnect the
machine from power when investigating or
correcting potential problems.
4
figure
. g0636XB switch disabling key and
on/oFF switch.
3.
press the oFF button to stop the machine.
4.
Without resetting the oFF button, press
the on button. the machine should not
start.
—if the machine does not start, the oFF but-
ton safety feature is working correctly.
—if the machine does start (with the oFF
button pushed in), immediately disconnect
power to the machine. the oFF button
safety feature is not working correctly. this
safety feature must work properly before
proceeding with regular operations. Call
tech support for help.
5.
twist the oFF button clockwise so it pops
out. When the oFF button pops out, the
switch is reset and ready for operation (see
figure 5).
Model g0636XB
Advertisement
Table of Contents
