Using An Extension Cable - Black & Decker BESTE625 Manual

ENGLISH
Be aware that freshly cut grass is
damp and slippery.
Never cross gravel paths or roads

while the machine is running.
Do not to touch moving hazardous

parts before the machine is
disconnected from the mains and the
moving hazardous parts have come to
a complete stop.
Never touch the cutting line while the

machine is running.
Do not put the machine down until the

cutting line has come to a complete
standstill.
Use only the appropriate type of

cutting line. Never use metal cutting
line or fishing line.
Be careful not to touch the line

trimming blade.
Take care to keep the mains cable

away from the cutting line.
Always be aware of the position of the
cable.
Keep hands and feet away from the

cutting line at all times, especially
when switching on the motor.
Never operate the machine with damaged

guards or without guards in place.
Take care against injury from any

device fitted for trimming the filament
line length.
After extending new cutter line always
return the machine to its
normal operating position before
switching on.
Do not use the lawn trimmer (edge

trimmer), if the cords are damaged or worn.
8
(Original instructions)
Keep extension cords away from

cutting elements.
Electrical safety
#
This machine is double insu-
lated; therefore no earth wire is
required. Always check that the
power supply corresponds to the
voltage on the rating plate.
If the supply cord is damaged, it must

be replaced by the manufacturer or an
authorised BLACK+DECKER Service
Centre in order to avoid a hazard.
Electric safety can be further improved

by using a highsensitivity 30 mA
Residual Current Device (RCD).

Using an extension cable

Always use an approved extension cable
suitable for the power input of this tool
(see technical data).
The extension cable must be suitable for
outdoor use and marked accordingly. Up
to 30 m of 1.5 mm2 HO5VV-F extension
cable can be used without loss of product
performance. Before use, inspect the
extension cable for signs of damage,
wear and ageing. Replace the extension
cable if damaged or defective. When
using a cable reel, always unwind the
cable completely.
Labels on machine
The following warning symbols are found on the machine
along with the date code:
Warning! Read the manual prior to operation.