Dennerle Nano ThermoCompact Series Operating Instructions

Congratulations on purchasing this high-end Dennerle product. We wish you years of enjoyment and pleasure with your aquarium!
1. Foreword
These operating instructions explain how to handle the 25 / 50 / 100 watt Nano ThermoCompact safely, hereafter referred to as a heater. Read these operating instructions fully before installing and using the heater
for the first time. Pay particular attention to the safety instructions. Please keep the operating instructions close to the heater at all times. Please pass on the operating instructions if you sell the heater or pass it
on in any other way.
2. Correct use
The heater is used for heating the aquarium and keeping the water temperature constant. It is only intended for indoor use at room temperature. Correct use also includes observation of and compliance with these
operating instructions, especially the safety instructions. Use for any other or additional purpose or unauthorised repairs or modifications shall be deemed improper. Improper use can lead to material damage and personal
injury. Dennerle GmbH assumes no liability for damage caused by improper use.
3. Safety instructions
• Check whether the voltage stated on the data plate matches the local voltage. For use with alternating current only,220-240 V – 50/60 Hz.
• Ensure the mains supply is protected by a residual current circuit breaker (maximum residual current 30 mA). If in doubt, ask your electrician.
• For indoor use only
• Always disconnect the heater from the mains (remove plug) before placing your hands in the water, draining the water or cleaning the aquarium! This also applies to all other electrical equipment in or on the
aquarium.
• The mains plug must be accessible at all times after installing the heater.
• Always ensure good flow around the heater by installing it near the filter or outflow.
• Risk of burning: the heater becomes hot when in use. Do not touch it with bare skin. Never switch it on outside the aquarium.
• Risk of overheating: the heater must be completely under water at all times. The maximum submersion depth is 80 cm.
• The heater cable and all cables leading from the aquarium must be fitted with a drip loop so that any water running down cannot reach the equipment or the mains socket.
• Deposits of calcium and other substances on the heater may impair its heat output and function. If the heater becomes dirty, clean it immediately.
• The heater is not intended to be used by persons (including children) with limited physical, sensory, or mental capacity, lack of experience, and/or lack of knowledge, unless said persons are supervised for
their own safety by another responsible person or are given instructions by this person on how to use the equipment. Children must be supervised to ensure that they do not play with the heater.
• Never open the housing.
• Check the power cable before setting up the heater and when carrying out maintenance. If there is any damage, remove the mains plug immediately, set the heater aside and dispose of it once it has cooled
down.
• The heater must not be disposed of with normal household waste. It should be disposed of at your local refuse centre.
4. Image key
No. Description No. Description
1 Heater 5 Marking on housing and mount
2 Mount 6 Indicator light
3 Suction cup 7 Power cable
4 Control dial with 8 Mains plug
scale
6. Cleaning
If there is a build-up of algae or calcium deposits on the heater, please clean it with a soft cloth or sponge. Before cleaning you must remove the mains plug (8) and leave the heater to cool for a reasonable time (approx. 30
mins) before removing it from the water.
7. Technical details
Voltage / frequency: 220-240 V 50/60 Hz
Maximum submersion depth: 80 cm
Protection rating: IP X8
Item no.
5697 5698
Unit
Wattage W 25 50
Weight
g 160 160
Height mm 160 160
Width mm 48 48
Depth
mm 27 27
8. Replacement parts
5695 2 suction cups
9. Warranty conditions
Warranty
In the event of a product being faulty, you have a warranty claim against your dealer in accordance with current statutory regulations.
Dennerle is nonetheless liable for damage caused to other property as a result of a fault in the product and for any resulting personal injury in accordance with the Product Liability Act.
Guarantee
Dennerle grants the buyer a 2-year guarantee from the date of purchase.
The guarantee covers manufacturing and material defects. During the guarantee period, Dennerle will replace and/or repair any defective parts free of charge. This is subject to the equipment having been used for its
intended purpose.
During the guarantee period, the equipment must only be opened by Dennerle after-sales service, otherwise the guarantee claim is void.
If you wish to make a claim, please contact your dealer or send the device with a valid receipt and sufficient postage to Dennerle after-sales service.
Subject to technical changes.
Technical after-sales service: Dennerle GmbH, Industriestrasse 4, D-66981 Münchweiler www.dennerle.com
English translation of the original German operating instructions
Nano ThermoCompact 25 / 50 / 100 Watt
Aquarium heater for fresh and saltwater aquaria
5. Setup and operation
• Attach the two suction cups (3) by inserting them into the fixing holes on the mount (2) and rotating them through 90°.
• Turn the control dial (4) until the desired temperature is above the arrow (5).
• Gently press the heater with the mount (2) onto the glass in a suitable, clean location in the aquarium.
• Guide the power cable (7) upwards out of the aquarium and avoid laying it over any sharp edges. Outside the aquarium the
power cable (7) must be fitted with a drip loop so that any water running down cannot reach the mains socket. Insert the
mains plug (8) into the mains socket as far as it will go.
• When the indicator light (6) is illuminated the heater is running. If your desired temperature is not reached (indicator light
(6) off) after a reasonable time, adjust the dial as necessary. Please note that it takes some time for the temperature in the
water to adjust. The temperatures on the control dial (4) are intended as a guide; check the water temperature with a ther-
mometer. The possible need to adjust the temperature after a certain period of operation is normal and does not constitute
grounds for complaint.
Protection class:
Accuracy:
Power cable length:
5699 Maximum achievable water temperature at a room temperature of 21 °C*
25 W
100
Aquarium size Aquarium size
200
210 10 L
48 20 L
30 L
27
*Guidelines. The actual temperature achieved depends on the insulation of the aquarium, cover, lighting, air circulation in the room, etc.
Sales: Dennerle GmbH, Kröpper Straße 17, D-66957 Vinningen
II
+- 1°C
1.4 m
50 W 100 W
Aquarium size
30 L 60 L
45 L 100 L
60 L 150 L
Maximum achievable water
temperature*
32 °C
29 °C
28 °C