PREFACE
This manual for Service engineers supplies all the technical information required for installing, testing and carrying
out maintenance interventions on the multifunction for bank front office MB-2 printer.
This manual can help you resolve a printer malfunctioning problem, when the solutions proposed in the Operating
Manual provided in the printer kit are not successful.
SUMMARY
The manual is subdivided into 7 chapters and an Appendix:
•
Chapter 1 Introduction - provides information of a general nature on the printer.
•
Chapter 2 Installation - describes the procedures and standards to follow for installing the printer.
•
Chapter 3 Operating the Printer - examines the operating procedures to follow to operate the printer correctly.
•
Chapter 4 Programming and Calibration - describes the procedures for programming the printer and
calibrating it.
•
Chapter 5 Diagnostics -all the defects that can be detected by the printer's diagnostics system are listed here.
•
Chapter 6 Maintenance - an illustrated procedure describes the cleaning, lubrication and mechanical adjustments
that may be necessary for the printer.
•
Chapter 7 Disassembling and Reassembling Parts - describes the procedures for disassembling and
reassembling again the main components of the printer.
•
Appendix - provides information regarding obtaining spare parts, and the software installed on the printer. An
illustrated procedure also describes how to update the printer firmware.
PRE-REQUISITES
The approach to the topics covered in this manual requires knowledge of similar products.
TECHNICAL SUPPORT CONTACTS
Email address: Banking.Printers@Olivetti.com
WEB Site: www.Olinet.biz
REFERENCES
Spare parts catalogue - cod. XZAC7261
DISTRIBUTION: General
FIRST EDI: November 2010
Y112890-3
Service Manual
III