Installation - Progress PBN 1310 User Manual

16 progress
Cooling fan motor
Total connection rating
Operating voltage (50 Hz)
Dimensions of the recess
Height - lower top edge
Height - in the recess
Width

Installation

Instructions for the Installer
Important!
Installation and connection must be
done in compliance with the regulations
in force. Any interventions must be
carried out when the appliance is
switched off. Only qualified service
engineers may repair the appliance
The manufacturing company disclaims
any liability if the safety measures are
not observed.
Connecting to the electrical supply
Before connecting to the electrical supply,
please make sure:
– The fuse and the domestic electrical in-
stallation must be designed for the max.
load of the appliance (see rating plate).
– The domestic electrical installation must
be equipped with a proper earth connec-
tion in accordance with the regulations in
force.
– The socket or the multi-pole off switch
must be easy to access after the appliance
has been installed.
This appliance is supplied with a connection
cable incorporating a standard plug, suitable
for the total electric load shown on the rating
plate. The plug is to be inserted into a suitable
wall socket.
The following types of mains cable are suit-
able, taking the necessary rated cross sec-
tion into account:
H07RN-F, H05RN-F, H05RR-F, H05VVF,
H05V2V2-F (T90), H05BB-F.
If the appliance is connected without a plug,
or if the plug is not accessible, a multipole off
switch (e.g. fuses, circuit breaker) with a min-
imum gap of 3 mm between the contacts
must be installed between the appliance and
mains cable. The switch must not interrupt
25 W Depth
1875 W
Oven cavity
230 V
Height
Width
600 mm Depth
587 mm Oven capacity
560 mm
the earth wire at any point. The yellow-green
earth wire should be 2-3 cm longer than all
other cables.
The connection cable must always be laid
out so that at no point does it reach 50°C
(over room temperature).
After the connection has been carried out,
the heating elements must be tested by be-
ing operated for about 3 minutes.
Terminal block
The oven is fitted with an easily accessible
terminal block which is designed to operate
with a single-phase power supply of 230 V.
Installation instructions
For ensuring a trouble free use of the installed
appliance, the unit or the column where the
appliance is to be installed should have ap-
propriate dimensions.
In accordance with the regulations in force,
all parts which ensure the shock protection
of live and insulated parts must be fastened
in such a way that they cannot be undone
without tools.
550 mm
335 mm
395 mm
400 mm
56 l