Controls - PEUGEOT METROPOLIS ABS 2021 User Manual

CONTROLS

Right controls.
4
3
2
1
1. Emergency stop button/Starter switch.
Set the button to this position in case of emergency
to stop the engine.
Set the button to this position before starting the
engine.
Press this button and simultaneously press the
right or left brake lever to start the engine.
2. System switch for Anti-Tilting.
For handling purposes, the vehicle has a hinge on the
front wheels allowing the two front wheels to tilt while
remaining parallel when taking a bend.
The Anti-Tilting system is used to lock this hinge and thus
stabilise the vehicle when it is moving at slow speed or
park the vehicle without using the stand.
Push the switch to this position to lock the front
axle. The warning light comes on with the emission
of a long beep.
Push the switch to this position to unlock the front
axle. The warning light goes off with the emission
of 2 beeps.
Conditions for locking the front axle manually
- The speed of the vehicle must be less than 11 km/hour
and the engine speed under 2800 rpm when the switch
is set to the locking position.
Conditions for automatic unlocking of the front axle
- The front axle is automatically unlocked if the speed of
the vehicle is greater than 11 km/hour and/or the
engine speed greater than 2800 rpm.
Manually unlocking the front axle
- Outside the conditions for automatic unlocking, set the
switch to the unlocking position.
Unlocking the front axle may lead to the
vehicle falling over. If the vehicle is
stopped with the rotating knob set to the
"on" position, do not operate the throttle
(engine running) or the Anti-Tilting
switch if the stability of the vehicle is not
under control.
The parking brake and the Anti-Tilting
might not hold the vehicle upright in all
situations. Load on the vehicle, steep
slope, prolonged immobilisation...
Preferably park the vehicle on the central
stand.
Reproduction or translation, even partial, is forbidden without the written consent of Peugeot Motocycles
3. Lighting switch/Daytime lights (DRL).
With the ignition on, push the switch to this
position. The daytime lights are on.
With the ignition on, push the switch to this
position. The daytime lights and dipped lights are
on.
The daytime lights
automatically 15 seconds
ignition is switched off.
4. "SELECT" selection button.
This control enables:
1
- access to the connectivity menu (Press and hold for 2
seconds).
- navigation within the menus (exiting a menu).
- confirmation of a choice (Press and hold for 2
seconds).
See chapter: Personalisation - Configuration menu.
1. Depending on model
switch off
after the
13/53