Replacing The Oil Filter; Coolant Level Check - PEUGEOT METROPOLIS ABS 2021 User Manual

• Insert the drain plug fitted with a new seal (Tightening
torque: 38 Nm).
• Pour the required quantity of oil corresponding to the
manufacturer's standards into the filler hole.
• Fit the cap/oil gauge.
• Start the engine and let it run for a short while.
• Check and adjust the oil level if necessary.
• Check that the oil drain plug is sealed.
Engine oil
SAE 5W40
100% Synthetic
Minimum grade API SL
Quantity:
- Without oil filter
replacement
- With oil filter
replacement
46/53

REPLACING THE OIL FILTER

We advise you to go to a registered
dealer for draining.
Oil contains substances which are
harmful to the environment. Your dealer
is equipped to dispose of used oil without
endangering the environment and in
compliance with current standards.
1.8 l
2 l
3
• Remove the oil filter cartridge (3) using an oil filter
wrench.
• Lubricate the rubber seal of a new oil filter
• Fit a new cartridge tightened by hand and lock it with a
1/4 turn.
• If you use a socket type oil filter wrench with square
fitting for use with a torque wrench, tighten the filter to
14 Nm.
• Check and adjust the oil level if necessary.
Reproduction or translation, even partial, is forbidden without the written consent of Peugeot Motocycles

COOLANT LEVEL CHECK

The filler cap/gauge is located in the rear shield panel
after removing the hatch.
The coolant level must be cold checked
regularly and topped up only with coolant
recommended by the manufacturer.
• Park the vehicle on its stand.
• Remove the header tank cap.
• Check the coolant level and if necessary top up in the
header tank until level MAX is reached.
MAX
MIN
Coolant PEUGEOT. Type C