Specifications - ForaCare Diamond PRIMA Owner's Manual

Error in performing
the test.
Control solution
vial was poorly
shaken.
Expired or
The control
contaminated
solution
control solution.
testing result
is out of
Control solution
range.
that is too warm or
too cold.
Defective test strip.
Device
malfunction.
Read instructions
thoroughly and repeat the
test again.
Shake the control solution
vigorously and repeat the
test again.
Check the expiration date
of the control solution.
Control solution, device,
and test strips should
be at room temperature
(20°C to 25°C / 68°F to
77°F) before testing.
Repeat the test with a new
test strip.
Please contact customer
service.
EN-17

Specifications

450 measurement results with respective
Memory
date and time
Dimensions 86 (L) x 53.6 (W) x 19.5 (H) mm
Power Source One 1.5V AAA alkaline battery
Weight 52.4 g (without battery)
External output USB Cable
Auto electrode insertion detection
Auto sample loading detection
Auto reaction time count-down
Features
Auto switch-off after 3 minutes without
action
Temperature warning
10°C to 40°C (50°F to 104°F), below 85%
Operating Condition
R.H. (non-condensing)
Storage/
-20°C to 60°C (-4°F to 140°F), below
Transportation
95% R.H
Condition
Measurement Units either mg/dL or mmol/L for glucose test
20 to 600 mg/dL (1.1 to 33.3 mmol/L) for
Measurement Range
glucose test
Hematocrit range 20~60% for glucose testing
Test Sample Capillary whole blood
Glucose measurements are reported as
Test Result
plasma equivalents
This device has been tested to meet the electrical and safety
requirements of: IEC/EN 61010-1, IEC/EN 61010-2-101, EN
61326-1, IEC/EN 61326-2-6.