Using The Power Smoothie Bowl - Ninja FOODI CB352ANZ Owner's Manual

USING THE POWER BLENDER & PROCESSOR PITCHER
& DOUGH BLADE ASSEMBLY – CONT�
6a If using an Auto-iQ program, use the dial
to select DOUGH, then press START/STOP.
The preset feature will automatically stop
at the end of the program. To stop the unit
at any time, press START/STOP.
6b For Manual mode, press IQ/MANUAL.
Use the dial to select speeds 1 or 2, and
press START/STOP. Once the ingredients
have reached your desired consistency,
press START/STOP, and wait for the unit
to come to a complete stop.
IMPORTANT: Only use speeds 1 or 2
when using the Dough Blade Assembly.
7 Remove the pitcher from the motor base
by turning it counterclockwise and then
lifting up.
14
AU 02 8801 7666 | NZ 0800 112 660
8 Remove the lid and Dough Blade
Assembly before removing contents. To
remove the lid, press the RELEASE button
and lift the handle. To remove the blade
assembly, carefully grasp it by the top of
the shaft and pull straight up. The pitcher
can then be emptied.
9 Turn the unit off by pressing the Power
button. Unplug the unit when finished.
Refer to the Care & Maintenance
section for cleaning and storage
instructions.

USING THE POWER SMOOTHIE BOWL

IMPORTANT: Review all warnings on
pages 4–6 before proceeding.
NOTE: If the unit is plugged in and powered
on, but the bowl and blade assembly is not
properly installed, the timer will display - -"
and the motor will be disabled.
NOTE: Auto-iQ programs have pauses and
changes in speed throughout the cycle.
1 Plug in motor base and place on a clean,
dry, level surface such as a countertop
or table.
2 Add ingredients to the Power Smoothie
Bowl. DO NOT add liquid past the
LIQUID FILL line or ingredients past the
MAX FILL line.
3 Place the Hybrid Edge Blades Assembly
on the top of the smoothie bowl and turn
clockwise to seal.
AU ninjakitchen.com.au | NZ ninjakitchen.co.nz
4 Turn the smoothie bowl upside down
and install on motor base by aligning the
tabs on the smoothie bowl with the slots
on the base. Then, rotate smoothie bowl
clockwise until it clicks. Once locked in
place, press the Power button to turn
unit on. The available program buttons will
illuminate and the unit will be ready for use.
NOTE: While processing, twist the built-in
tamper counterclockwise continuously.
5a If using an Auto-iQ program, use the dial
to select the program that best suits your
desired output, then press START/STOP.
During the blending process, ensure to
twist the built-in tamper counterclockwise
continuously. The preset feature will
automatically stop at the end of the
program. To stop the unit at any time,
press START/STOP.
15