Using The Auto-Iq Programs - Ninja FOODI CB352ANZ Owner's Manual

USING THE AUTO-IQ PROGRAMS

AUTO-IQ PROGRAMS
Intelligent preset programs combine unique blending and pausing patterns that do
the work for you. Once a preset program is selected, it will start immediately and
automatically stop when blending is complete. To stop blending before the end of the
program, press the currently active button again.
NOTE: The unit can detect if the pitcher or the cup/bowl is installed on the motor base.
Only the functions available for a particular container will illuminate on the control panel.
AUTO-IQ PROGRAMS FOR
THE PITCHER
SMOOTHIE
Combine your favorite fresh or frozen
ingredients, liquids, and powders to create
smoothies and protein shakes.
SPREAD
Create anything from spreadable nut butters
to zesty dressing to the perfect hummus.
BOWL
Make thick, spoonable smoothie bowls to
creamy frozen yoghurt to refreshing sorbets.
CHOP
Timed pulses and pauses give you
consistent chopping results. Run program
once for a large chop, twice for a small chop
and three times if you prefer to mince.
DOUGH
Used with the Dough Blade Assembly,
create delicious dough for pizza, bread,
and baked goods like cookies.
10
AU 02 8801 7666 | NZ 0800 112 660
AUTO-IQ PROGRAMS FOR THE
POWER NUTRI CUP AND SMOOTHIE BOWL
EXTRACT
Ideal for tough, leafy, or fibrous whole fruits
and vegetables, including their skins, seeds,
and stems.
SMOOTHIE
Combine your favorite fresh or frozen
ingredients, liquids, and powders to create
smoothies and protein shakes.
NOTE: For best results when using
the Power Nutri Cup, use the Auto-iQ
Programs, EXTRACT & SMOOTHIE.
SPREAD
Create anything from spreadable nut butters
to zesty dressing to the perfect hummus.
BOWL
Make thick, spoonable single-serve
smoothie bowls to creamy frozen yoghurt
to refreshing sorbets.
NOTE: For best results when using the
Power Smoothie Bowl, use the Auto-iQ
Programs, SPREAD & BOWL.
USING THE POWER BLENDER &
PROCESSOR PITCHER & STACKED BLADE ASSEMBLY
IMPORTANT: Review all warnings on
pages 4–6 before proceeding.
IMPORTANT: As a safety feature, when
the unit is powered on, if the pitcher and
lid are not properly installed, the timer
will display "- -" and the motor will be
disabled. If this happens, repeat steps 2
and 5 on this page. When the pitcher and
lid are properly installed, and the unit is
powered on, the program button LEDs
will illuminate, indicating the appliance is
ready to use.
NOTE: Auto-iQ programs have pauses and
changes in speed throughout the cycle.
NOTE: DO NOT add ingredients before
completing installation of the Stacked
Blade Assembly.
NOTE: If the Stacked Blade Assembly is
not fully seated, you will not be able to
install and lock the lid.
NOTE: The pitcher lid handle will not fold
down unless it is attached to the pitcher.
1 Plug in motor base and place on a clean,
dry, level surface such as a countertop
or table.
AU ninjakitchen.com.au | NZ ninjakitchen.co.nz
2 Lower the pitcher onto the motor base.
The handle should be aligned slightly
to the right and the pitcher should be
oriented so the LOCK symbols are visible
on the motor base. Rotate the pitcher
clockwise until it clicks into place.
3 Exercising care, grasp the Stacked Blade
Assembly by the top of the shaft and
place it onto the drive gear inside the
pitcher. Note that the blade assembly
will fit loosely onto the drive gear.
4 Add ingredients to the pitcher. DO NOT
add ingredients past the MAX LIQUID
line on the pitcher.
5 Place the lid on the pitcher. Press down on
the handle until it clicks into place. Once
the lid is locked in place, press the Power
button to turn unit on. The available
program buttons will illuminate and the
unit will be ready for use.
11