Leveling The Appliance; Reversing The Door; Tools You Will Need - Bertazzoni REF24BMFXNV User Manual

3. REVERSING THE DOOR

Note
> This appliance is intended to operate in the
climate class ranging between 55~110°F. It
may not work properly if left at a temperature
above or below the indicated range for a long
period.
> Install your appliance in a dry place to avoid
high moisture.
> Keep the appliance away from direct
sunlight, rain and frost. Situate the appliance
away from heat sources such as stoves, fires
or heaters.

2.3 Leveling the appliance

> In order to ensure that the appliance is level and
that air circulation at the lower rear section of the
appliance is sufficient, the bottom feet may need to
be adjusted. You can adjust them by hand or using an
appropriate wrench.
> To allow the doors to self-close, tilt the top backwards
about 1/2 ".
3.1 Reversing the door
The side at which the door opens can be changed,
from the right side (as supplied) to the left side, if the
installation site requires it.
Warning!
When reversing the door, the appliance must
not be connected to domestic power. Ensure
that the plug is removed from the power
outlet.
8

3.2 Tools you will need

Not provided
8mm socket wrench
Phillips screwdriver
> When required, tilt the refrigerator back in order to
gain access to the base; rest the appliance against
soft foam packaging or similar material to avoid
damaging the refrigerator's backboard. To reverse
the door, the following steps are generally required.
Different models may correspond to different images.
Models will be identified in the images. If certain
parts are not shown in an image, please ignore any
description pertaining to them.
1) Stand the refrigerator upright. Open the upper door
to take out all of the door racks (to prevent them from
being damaged) and then close the door.
2) Remove part
and free part
side of refrigerator.
Flat-bladed screwdriver
8mm wrench
Door racks
from the top right