Jumper St3; Led; Dip-Switch - gefran KFM05a Instruction Manual

3.1.5 Jumper ST3

With this jumper, the logic of the inputs is defined.
FRONT = 24V reference X7:1
BACK = GND reference X7:2, standard
Therewith, the inputs can be adjusted to any controller as described below. The default
configuration (BACK) corresponds to the connection examples.

3.1.6 LED

Status-LED
LED 4
LED 2
LED 1
LED 1 GREEN
LED 2 YELLOW
LED 3 RED flashes
LED 4 GREEN
LED 5 YELLOW on
off
LED 6 GREEN on
off

3.1.7 DIP-Switch

Assignment of the DIP-Switch
S3.1 Modbus-Protocol
S3.2 Special function
S3.3 Fieldbus-controller active
S3.4 Option
S3.5 Configuration Analog Input 1
S3.6 Configuration Analog Input 2
Switch ON  Function active
Standard all OFF
Switch S3.5 und S3.6
Art.-No.: 918 111e
SIEI-AREG GmbH
Gottlieb-Daimler-Straße 17/3
74385 Pleidelsheim Germany
Fon: +49 7144 89736 0
LED 3
LED 6
LED 5
option
option
error
option
enable is set
power amplifier disabled
ready
reset is set
0 – 10 V / 0 – 20 mA
0 – 10 V / 0 – 20 mA
switch to the bottom
switch to the edge of the board
OFF  0 – 10 V voltage input
ON  0- 20 mA current input
Page 26 von 60 Rev. 09/14