Table of Contents
Advertisement
Install the docking assembly.
• Docking station must be secured in accordance with these instructions to ensure ice machine
stability.
• Ventilation openings in the docking station should be clear of obstruction
Wall bracket accessory
• Mount docking assembly to wall bracket
accessory
4.1
Undercounter installation requirements Horizon 1010 & 1410 series
DOCKING STATION
• Position and screw docking assembly to the bottom of counter inside of access panel/door
1010/1410: 2.25" (57 mm) from the front edge of asembly
710: 3.25" (82.55 mm) from the front edge of the cross brace
• The mounting surface for the docking assembly must be solid.
Do not mount directly onto runners or channels.
• There must be no lip or edge that would hinder the ice machine from sliding in or out of the
docking station
➋
INTAKE AND EXHAUST GRILLE PLACEMENT: Air-cooled models only
• Position the intake grille cut out in the access panel/door
Note: Ice machine must be aligned with cut out and inside of access panel to provide a tight
seal and prevent recirculation of hot exhaust air.
• Left edge of cutout from the left side of the ice machine
1010/1410: 2.25" (57 mm)
710: 2" (51 mm)
• Bottom edge of cutout should be 2" (51 mm) from the bottom of the ice machine
• Position supplied exhaust grille at least 18" (458mm) away from intake grille
Where possible, install exhaust grille to the rear or side of the base cabinet.
• If not using supplied grille, air circulation requirements below must be met:
1010/1410: 250 sq. in (1613 sq cm) intake/exhaust air
710: 160 sq. in (1032 sq cm) intake/exhaust air
Cornelius • RIDE Technology
WARNING
• Mount docking assembly to machine
self-contained
Docking assembly
Machine stand accessory
stand accessory
➌
➎
4
➊
➍
.
9
Advertisement
Table of Contents
