Connecting The Usb Nano Receiver - Silvercrest OMC807 User Manual

Mouse with charging cradle OMC807
Should the wireless mouse fail to work, power it off
and back on. Sometimes removing and re-inserting
the batteries will also help.
After inserting a rechargeable battery into the mouse
or powering the mouse on, the indicator (8) will flash
several times during automatic synchronisation with
the receiver. When the synchronisation is completed,
the status indicator will stop lighting.
The power for charging the battery is obtained from
the computer's USB port. Depending on your
computer, the USB power may be cut when the
computer is powered off. In this case, you may only
charge the wireless mouse battery when the
computer is powered on.

Connecting the USB Nano Receiver

Connect the USB Nano Receiver (12) to a free USB port of your
running computer.
The operating system will automatically recognize the new
hardware and install the required drivers. Depending on the
operating system installed, the following screen messages may
appear:
®
Windows XP
When the receiver is connected for the first time, the operating
system displays the message „New hardware detected". Wait
until the message „The new hardware has been installed and is
now ready for use" is displayed before using your mouse.
Windows Vista
When the receiver is connected for the first time, the operating
system displays the message „Installation of appliance driver
software". Wait until the message „The appliances are ready for
use now" appears. The mouse is now operational and ready to be
used.
72 - English
® ®
, Windows 7