Installing The Touch Screen Wired Control - Baxi JSGNW Installation And Support Manual

5.3.

INSTALLING THE TOUCH SCREEN WIRED CONTROL

Use a flathead screw driver to pry the bottom groove of the wire controller lightly (too much force
would damage circuit board), pry rotationally to open the back cover.
As shown in Fig.3, fix φ4 * 20mm screws provided together with the back cover on 8 6 box, then
pass lead wires through the back cover.
After connecting the connecting wire to the main body of the wire controller, install main body part
according to the following steps:
1).Push the upper part of main body into the clip.
2).Use the force of inclined top to install the lower part of main body (horizontal installation is
prohibited, which is easy to damage the structural slot).
26