Wiring; Power And Connection Wiring - Baxi JSGNW Installation And Support Manual

7. WIRING

7.1.

POWER AND CONNECTION WIRING

The connection cables must comply with the specifications listed in the table below.
OUTDOOR UNIT MODEL
CONNECTION CABLE
SPECIFICATIONS
POWER CABLE
SPECIFICATIONS
Connect the power supply to the outdoor unit and conduct the wring connection as
-
shown on the below diagram:
 N.B.
The connection wire of indoor units should be connected to the corresponding
-
terminal board; otherwise it will cause the unit failure or even damage the units.
The diagram below is just an example of a 5x1 outdoor units connected. Wall,
-
floor/ceiling, cassette and duct can be connected to any of the outdoor unit terminal
boards.
Connect the earth wire correctly, otherwise will cause the malfunction of some
-
electrical component and shock or fire indeed.
- Don't reverse the power polarity.
Must fix the screw nail of the firmly wire, then drag the wire lightly, confirmation
-
whether it's firmly.
LSGT40-2M LSGT50-2M
2
3x1.5 mm +E 3x1.5 mm
2
2x2.5 mm +E 2x2.5 mm
LSGT60-3M LSGT70-3M
2 2
+E 3x1.5 mm +E 3x1.5 mm
2 2
+E 2x2.5 mm +E 2x4.0 mm
30
LSGT100-4M LSGT125-5M
2 2
+E 3x1.5 mm +E 3x1.5 mm
2 2
+E 2x4.0 mm +E 2x4.0 mm
2
+E
2
+E