2. Use a plastic scribe to pry open the outside left and right edges of the display panel.
CAUTION:
Prying from the bottom edge of the panel may damage components located near the bottom of the
display assembly.
3. Carefully flip the display panel to access the display cable.
4. Peel back the conductive tape that secures the display cable to the back of the display panel.
5. Peel and remove the rubber spacer on the display cable.
6. For systems that support USI pen, disconnect the USI pen cable from the connector on the back of the display panel.
7. Disconnect the display cable from the connector on the back of the display panel.
8. Lift and remove the display panel from the display assembly.
Installing the display panel
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the display panel and provide a visual representation of the installation procedure.
Removing and installing components
43